These tools will no longer be maintained as of December 31, 2024. Archived website can be found here. PubMed4Hh GitHub repository can be found here. Contact NLM Customer Service if you have questions.


Pubmed for Handhelds

PUBMED FOR HANDHELDS

Search MEDLINE/PubMed

  • Title: Effects of different burs on dentin bond strengths of self-etching primer bonding systems.
    Author: Ogata M, Harada N, Yamaguchi S, Nakajima M, Pereira PN, Tagami J.
    Journal: Oper Dent; 2001; 26(4):375-82. PubMed ID: 11504437.
    Abstract:
    This study evaluated the effects of cutting dentin with different types of burs on tensile bond strength using three self-etching primer bonding systems (Clearfil Liner Bond 2 [LB2], Clearfil Liner Bond 2V [2V] and Clearfil SE BOND [SE], Kuraray, Co, Ltd, Osaka, Japan). Thirty-six intact extracted human third molars were ground flat to expose occlusal dentin, followed by polishing the dentin surfaces with #600 SiC paper. The teeth were divided into four groups according to bur type and grit: fine cut fissure steel bur (SB600), cross cut fissure steel bur (SB703), regular grit diamond bur (DB). Controls were abraded with #600 grit SiC paper (AP#600). The dentin surfaces of the SB600, SB703 and DB groups were cut under copious air-water spray with the respective burs mounted in a dental handpiece. The teeth were treated with one of three adhesive systems, then composite buildups were created with Clearfil AP-X (Kuraray Co, Ltd, Osaka, Japan). After soaking in water at 37 degrees C for 24 hours, serial vertical sections (0.7 mm thick, 7-8 slices per one tooth) were made, trimmed to form an hour-glass shape with a 1.0 mm2 cross-section and tensile bond strengths were determined at a cross-head speed of 1 mm/min. Statistical analysis was made using one and two-way ANOVA and Fisher's PLSD test (p<0.05). Eight additional molars were prepared. Burs or abrasive paper were used for SEM observations of the dentin surfaces of each group before and after treatment with the self-etching primers. All adhesive systems yielded the same ranking of bond strengths to the surfaces prepared with different abrasives: from highest to lowest, AP#600 > SB600 > SB703 > DB. This ranking reached statistical significance using Clearfil Liner Bond 2V (p<0.05). Therefore, when cutting dentin, selecting the adequate bur type is important for improved bonding of adhesive systems using self-etching primer to dentin.
    [Abstract] [Full Text] [Related] [New Search]