These tools will no longer be maintained as of December 31, 2024. Archived website can be found here. PubMed4Hh GitHub repository can be found here. Contact NLM Customer Service if you have questions.
Pubmed for Handhelds
PUBMED FOR HANDHELDS
Search MEDLINE/PubMed
Title: Comparison of photo-activation versus chemical or dual-curing of resin-based luting cements regarding flexural strength, modulus and surface hardness. Author: Hofmann N, Papsthart G, Hugo B, Klaiber B. Journal: J Oral Rehabil; 2001 Nov; 28(11):1022-8. PubMed ID: 11722718. Abstract: This study investigated the efficiency of chemical activation of dual-cure resin-based luting cements as compared with light- and dual-curing. Curing was performed by (i) mixing base and catalyst without subsequent irradiation (chemical curing=CC), (ii) mixing base and catalyst with direct irradiation (dual-cure=DC) or with (iii) irradiation through 2.5 mm of leucite-reinforced glass-ceramics (IPS Empress, Ivoclar) (dual-cure through porcelain=DCtP), (iv) using only the base paste with direct irradiation (light-curing=LC) or with (v) irradiation through porcelain (light-curing through porcelain=LCtP). Specimens of four fine-hybrid DC resin composites and one self-cure hybrid resin composite (only CC) were prepared and tested after 24 h for flexural strength, modulus of elasticity (ISO 4049) and surface hardness (Vickers). For all materials and parameters, dual-curing produced higher values than LC, even when irradiation was performed through porcelain. Following self-curing without photo-activation, flexural strength was 68.9-85.9%, the modulus 59.2-94.5% and Vickers hardness 86.1-101.4% of the corresponding values obtained by dual-curing with direct irradiation. Light-curing through porcelain as compared with direct irradiation reduced the values for most parameters and materials. In contrast, dual-curing maintained flexural strength for all, the modulus for three and the hardness for one of the materials. The mechanical properties of the self-curing resin cement ranged between those of the DC materials.[Abstract] [Full Text] [Related] [New Search]