These tools will no longer be maintained as of December 31, 2024. Archived website can be found here. PubMed4Hh GitHub repository can be found here. Contact NLM Customer Service if you have questions.


Pubmed for Handhelds

PUBMED FOR HANDHELDS

Search MEDLINE/PubMed

  • Title: [Noise level measurements of the air noise during drilling and grinding on the fresh isolated temporal bone (author's transl)].
    Author: Paulsen K, Vietor K.
    Journal: Laryngol Rhinol Otol (Stuttg); 1975 Oct; 54(10):824-34. PubMed ID: 129600.
    Abstract:
    Aerial sound measurements with different drilling instruments were performed during dry running and preparations of the bone. Registered were the values of the small drilling instruments Sirona, Dentatus-Air, and Electro-Torque-Ritter. Also tested were the KaVo-Technique-machine, the Hall-machine, the Air-Orbit-turbine, and the Sirona-turbine. During dry running most of them already reached the allowed marginal value of noise nuisance for the ear of 85 dB (A) at a distance of 35 cm. Only the Air-Orbit-machine showed a slightly lower value of 80 dB (A). The level increases with the used handpieces. Normal handpieces 1:1 exert only a minimal influence, gear handpieces 2:1, however, markedly increase the level. The verticity is of no importance in the range of normal rotations between 10,000 r/min. and 80,000 r/min. Only rotations in the lower frequency range of 2,000 r/min. markedly decrease the noise level. During bone drilling, the kind and size of the drilling bit have an influence on the intensity of the noise level. Quadruple wing milling cutters create a very high noise level (at a distance of 15 cm still above 110 dB [A!]), big rose cutters (R 16) create noise levels of 95 dB (A) and above, and only diamond round bits create less noise (approximately 88 db [A]). Small drilling bits make such a faint noise, that it is overroared by the drilling instrument. The turbines create only slightly higher levels than during dry running. Larger drilling bits cannot be employed here on principle. Wing milling cutters can lead to persistent damages of the inner ear. The frequent use of dental drilling instruments for bone preparations can also lead to a hearing loss of the operator in the long run.
    [Abstract] [Full Text] [Related] [New Search]