These tools will no longer be maintained as of December 31, 2024. Archived website can be found here. PubMed4Hh GitHub repository can be found here. Contact NLM Customer Service if you have questions.


Pubmed for Handhelds

PUBMED FOR HANDHELDS

Search MEDLINE/PubMed

  • Title: Chlorobenzene oxidation using ozone over iron oxide and manganese oxide catalysts.
    Author: Wang HC, Liang HS, Chang MB.
    Journal: J Hazard Mater; 2011 Feb 28; 186(2-3):1781-7. PubMed ID: 21227575.
    Abstract:
    A low-temperature catalytic oxidation of chlorobenzene (CB) has been performed at temperatures of 60-210°C using ozone (O(3)) over iron oxide and manganese oxide, respectively. In the absence of ozone, CB conversion achieved with these two catalysts at 200°C was below 10%. However, addition of 1200 ppm ozone results in a remarkable increase in CB conversion and the conversion reaches 91.7% at 150°C for iron oxide, while 81.5% conversion is achieved with manganese oxide at 90°C. The activation energy of manganese oxide (48 kJ mol(-1)) is higher than that of iron oxide (43 kJ mol(-1)) without ozone. However, as ozone is added, the activation energy is significantly reduced to 20.0 kJ mol(-1) for iron oxide. CO and CO(2) are the only carbon-containing products detected in the effluent gas stream. For the long-term test, no obvious deactivation was found in iron oxide and ozone. However, in the case of manganese oxide and ozone, 3% reduction of CB conversion was observed. Slight deactivation might be attributed to a small amount of reaction byproducts (carboxylic acid species) and residual chloride (MnCl(2)) being deposited on the active sites of the catalysts.
    [Abstract] [Full Text] [Related] [New Search]