These tools will no longer be maintained as of December 31, 2024. Archived website can be found here. PubMed4Hh GitHub repository can be found here. Contact NLM Customer Service if you have questions.


Pubmed for Handhelds

PUBMED FOR HANDHELDS

Search MEDLINE/PubMed

  • Title: Curing efficiency of three different curing modes at different distances for four composites.
    Author: Zhu S, Platt J.
    Journal: Oper Dent; 2011; 36(4):362-71. PubMed ID: 21834705.
    Abstract:
    This study investigated the influence of the different curing distances with three polymerization modes in terms of the surface microhardness of four resin composites as a function of energy density. A hybrid resin composite and flowable composite from each of two manufacturers were evaluated. The specimens were polymerized with one of two light-curing units: 1) Mini LED AutoFocus (1500 mW/cm2) with a fast curing mode, for which two polymerization regimens were used: a) one AutoFocus function cycle and b) two AutoFocus function cycles, and 2) LEDemetron I (950 mW/cm2) with a 20-second curing time. Polymerization was performed with the curing tip at a distance of 0 mm, 3.0 mm, 6.0 mm, and 9.0 mm from the top surface of the specimen, and the power density of each light source was measured with a spectrophotometer. All specimens were stored in distilled water in a light-proof container at 37°C for 24 hours, and their top and bottom surface Knoop hardness numbers were determined. Microhardness data were submitted to two-way analysis of variance and multiple comparisons with a Tukey test. All statistical analyses were performed at a significance level of 0.05. Though the curing lights tested exhibited a decrease in power density with distance, the rate and extent of power density loss were not the same. The polymerization mode and curing tip distance had a significant effect on the composite microhardness. There was also a significant interaction among polymerization mode, curing tip distance, and microhardness. The curing ability of the three polymerization modes was ranked in terms of the hardness percent values: the LEDemetron I > two cycles of the Mini LED AutoFocus > one cycle of the Mini LED AutoFocus.
    [Abstract] [Full Text] [Related] [New Search]